BIGTREETECH Manta M8P

Wiring

Open Full Size Image

if you use the Ratrig endstop switches and cables, do not blindly plug them in to your M8P as doing this will short the board's 5V power rail.

You will probably have to swap the outer two wires (red and white) on the board end of the cable but double check to make sure your cables match the wiring diagram in both ends. Orders shipped after October 2022 should have the correct cables (the connectors on the new cables are white).

Jumpers

A green square is where you would place a jumper, remove all jumpers on the board that are not marked by this symbol.

FAN Wiring